GE IS230SNRTH2A Gas Turbine Control Systems Base module

Product Introduction

GE IS230SNRTH2A Gas Turbine Control Systems Base module.The entire module is regarded as the least replaceable unit, and no assistance is provided to diagnose or replace the individual boards that comprise the module./Power is supplied to a JGPA board via connector P4. The module is connected to TCAT via two 68-pin cables on connectors P1 and P2.

The IDs of the 21 plug-in relays are prefixed with K and end with a number. The numbers are in sequence beginning with 1. Some of the IDs are K1, K5, K10, and K21. The relays snap into place on the board and are help in place with metal straps. To remove a relay, detach the metal strap and pull the relay out of the connector. To install a relay, align it with the connector and press it into the connector. Then, clip one end of the metal strap to the connector, arrange the metal strap over the top of the relay, and clip it to the other side of the connector.