Product Description
GE created the DS200AAHAH2A as a part of the Speedtronic Mark V LM series of ARCNET HUB LAN Driver Boards. As a legacy series, GE no longer offers any type of support for this board. AX Control does, however, attempt to keep this board in stock.
The DS200AAHAH2A is a very simple board. It has two different connections on its top edge. On the top right corner is the ARCBNC-A port and to the left of it is the ARCBNC-B port. These provide ARCNET communication. On the face of the board are two different connection ports. In the middle of the bottom edge is an APL 10-Pin port. And then finally, in the right bottom corner is a 2PL connection port that provides power to the <R> core form the TCPS board. After this board is connected to the other hardware, there are no further modifications of software that is needed for it to function properly.
Frequently Asked Questions about DS200AAHAH2A
Which topology is DS200AAHAH2A used with?
The ARCNET network supports bus, star, and distributed star topologies.The star topology requires DS200AAHAH2A. DS200AAHAH2A is used to concentrate the cables from each of the nodes. The distributed star topology, which is when all nodes connected to an active hub or DS200AAHAH2A with all hubs cascaded together, offers the greatest flexibility and allows the ARCNET network to extend to greater than 4 miles without extended timeouts.
What is the primary function of DS200AAHAH2A?
The primary function of DS200AAHAH2A is to provide a convenient method of expanding a network.
What is DS200AAHAH2A used for?
DS200AAHAH2A is used for the Stage Link connections on the < R > core via the UCPB board. DS200AAHAH2A is also used for COREBUS connections between the < R > core and the I/O cores through the PANA board.
What connectors does DS200AAHAH2A have?
DS200AAHAH2A has two BNC connectors for ARCNET communication.
There are no reviews yet.